Dorman926-173 Front Wheel Hub Bolt Compatible with Select Jeep Models, 3 Pack

Nice replacement for 12 point 13mm bolts on the hub set of my jk

Replacement bolt for Dana 30 and 44 unit bearings. A must have if you have salt and rush issues when you work on the front axle

Fit as the should with no issues

I had to replace the wheel hubs on my 2004 Jeep TJ and the OEM 12-points were a PITA to remove. I soaked in PB Blaster, used a small torch to heat, smacked with a hammer to loosen and still stripped two of the six.I found these by accident but the large 6-point head is the way it should have been from the factory. Using a 6-point wrench there's zero chance of rounding them off in the future. If you're going to pull the hub bolts, buy these and have them in hand to put it back together.

Dorman 926-173 Front Wheel Hub Bolt Compatible with Select Jeep Models (JK Wrangler 2012)Items work as they should.Jeep JK Wrangler with over 150,00 miles.(Ease of install is directly related to the condition of your wheel components.)(Cost is relative. When you need it you need it. Cost was still less expensive than purchasing locally.)

Worked great, but i had to cut off the original wheel bearings since the oem 12pt bolts corroded so badly.These fix that design flaw for the next time around.If your 12pt bolts are ok, i would say still replace them with these!!

Needed these in a pinch, direct fit for jeep wj hub bolts

Worth the money! Way better and stronger then the 12 point blots that come from the factory

Perfect fit.

I used them and they are good qualityi like them because you don't have to have 12 point socket for this like factory has 12 point.

Fit good I think they are better than the Oem bolts will find out if I ever have to replace the hubs in the future ,which is a given

Sure beats the heck out the rusty hard to remove 12 point 13mm bolts from the factory!!

Won’t have to mess with a 11 point 13mm next time