MITZONE Upgrade Aluminium Oil Cooler Filter Housing compatible with VW Jetta GTI Golf R Passat Audi A4 A3 TT TTS 2.0L Replace 06F115397K 06F115397J 06F115397H

This product was perfect !!!!!! I have a 2007 Audi a4 2.0I had been chasing leaks due to having excess oil in engine, causing oil leaks.I bought this and vacuum pump seal kitVery high quality!! If you need to replace your oil cooler just replace the whole unit.I did buy own gaskets tho from ECS TUNING! The originals are cheap.

Gotta take off the oil cooler to get to bolts. Not a big deal. Fit properly on 07 a4 quattro cabriolet with 2.0t. Not a simple job but not overly difficult either.

Perfect fitment. I read some reviews about one of the hoses not fitting properly and having to do some adjustments, but on my case I didn't had to do any modifications. Not sure if they fixed their design or just my luck. Great upgrade compared to the plastic OEM

Got this for my MK6 Golf R and it worked great. The only thing that sucked was the install. I did take the advice of others on here and got the ECS lines to avoid any figment issues that may happen.Have had it on the car for about 6 months and no oil or coolant leaks.Great product, would recommend to anyone that has a leaking oil filter housing assembly that needs replaced. Or a preventative measure.

Installed this oil cooler housing on my 2008 2.0t A4. Fit great with no problems at all.

Pcv tube doesn't fit without modification. A little grinding made the stock tube fit without having to purchase aftermarket hoses. Would be 5 stars if it fit without modification.

you will definitely want to get the ECS silicone PVC hoses, P/N :ES#3412048 for the lower, I did the full set P/N: ES#4000101. Install is messy, plan on oil change, you will get coolant in oil when changing this out.I had previously replaced seals on the original housing, a short while later the original cracked, and I replaced with an aftermarket(got a local shop to do) that housing lasted less then 6 months, I checked the rear with a flat edge, and realized that the aftermarket housing had warped, so even if I replaced just the gasket, it would still leak. I was happy to find this and the reviews were great-even if the original PVC hoses would not work. being prepared with the silicone hoses was good, because my original PVC hoses ended up falling apart(brittle plastic) and so would have needed replacing anyways.I wholeheartedly say this was a fantastic upgrade to the stock plastic. Car has been leak free for 3 months now.

This Mitzone assembly would not hold a vacuum in the coolant system. I installed it twice, double-checked to ensure that the mating surfaces were clean and that the gaskets were seated, and tried different gaskets. I swapped to an Audi Genuine assembly and it held vacuum no problem. It appears to me that the casting of the Mitzone assembly was flawed. It looked like the part of the gasket around the coolant hole was sunk into the channel more than the rest of it.